Nylon Wall Plug 10mm for climbing holds

10x50mm nylon plug, In combination with the 8x60 barraquero screw.  It is a very economical solution for placing climbing holds on brick walls in home climbing walls. They have the drawback of not being able to reuse them to move the holds over and over again, but their low cost makes them a good alternative in terms of value for money.

When using this system, it is recommended to put some styrene-free polyester resin at the base of the hold to prevent it from turning. Note: This type of plug does not meet the resistance requirements required by the UNE-EN 12572:2017 standard. For this reason, we recommend always using the anchoring system with a chemical plug. Model: Industrial Multimaterial plug. VZ. 00 10 050